Volvo XC90 2020 Owner's Manual page 625

3. Repeat the steps in point 2 above to
secure the other hook in the mounting on
the other side.
WARNING
Make sure the hooks of the safety grille are
securely fitted in the roof mountings so
there is no risk of the grille coming loose.
4.
Hook the attaching brace's hook through
the load securing eyelet at the cargo floor
from underneath, and guide the threaded
part through the cargo grille's lower
attachment hole from underneath (1).
Slide a plastic sleeve on the threaded part
of the attaching brace - the sleeve flange
should face up - and guide it down
through the hole. Then screw on the screw
cap until its lower edge is approx. 5 mm
from the grille (2).
5. Repeat the steps in point 4 on the other
side.
6. Centre the safety grille and then tighten
the two attaching braces alternately until
the grille is properly secured.
Removal
Remove the safety grille by performing the
above steps in reverse order.
Note that the attaching braces can be
removed before the plastic sleeves are
removed from the holes in the grille.
Related information
Recommendations for loading (p. 615)
•
Load retaining eyelets (p. 618)
•
LOADING, STORAGE AND PASSENGER COMPARTMENT
Fitting and removing the safety
net*
The safety net prevents loads from being
thrown forward in the passenger compart-
ment in the event of sudden braking.
The safety net is fitted into four mounting
points.
For reasons of safety, the safety net must
always be fastened and anchored as descri-
bed below.
The net is made of a strong nylon fabric and
can be secured two different locations in the
car:
Rear fitting - behind second seat row.
•
Front fitting - behind the front seats.
•
}}
623
* Option/accessory.