Advertisement
Pinion Assembly/Clutch Armature/Clamp
Pinion Assembly/Clutch Armature Removal
Pinion Assembly
If pinion assembly (29) is not removed from clutch housing
(19), do 1. through 3. Otherwise, start at 4.
WARNING
Read Injection Hazard, page 3; Burn Hazard, page 4
1.
Remove drive housing; page 9.
2.
F
. 4. Disconnect clutch cable connectors from inside of
IG
pressure control.
a.
F
. 14. Remove two screws (71) and swing down
IG
cover (130a).
b.
Disconnect engine leads from board to engine.
c.
Remove strain reliefs 130r and 123.
3.
F
. 4. Remove four screws (36) and pinion assembly (29).
IG
F
. 4
IG
4.
F
. 5. Place pinion assembly (29) on bench with rotor
IG
side up.
5.
Remove four screws (28) and lock washers (24). Install
two screws in threaded holes (E) in rotor. Alternately
tighten screws until rotor comes off.
10
F
6.
7.
19
F
Clutch Armature
8.
9.
10. Remove armature.
F
Pinion Assembly/Clutch Armature/Clamp
29
. 5
IG
F
. 6. Remove retaining ring (29b).
IG
Turn pinion assembly over and tap pinion shaft (29a) out
with plastic mallet.
. 6
IG
F
. 7. Use an impact wrench or wedge something
IG
between clutch armature (25) and clutch housing to hold
engine shaft during removal.
Remove four screws (23) and lock washers (24).
. 7
IG
310893J
Advertisement
