Download Print this page

Mitsubishi Electric Mr.SLIM PC-2GJA Technical & Service Manual page 5

Split-type, cooling air conditioners

Advertisement

Remote controller
TIMER / TEMP.
This button is used to change
between display of room tem-
peratue and display of remain-
ing timer time durining "AUTO
STOP" operation. Green lamps
light in selected display mode.
Lamps display remaining
timer time or room temper-
ature.
Remaining timer time display
Lamps indicate time remaining
until timer stops timed operation.
Green lamps corresponding to
remaining number of hours light.
Room Temperature display
Lamps display temperatue set-
ings and actual room tempe-
ratues.
Temperatue settings.
Green lamps light.
Temperatue in room.
Green lamps flash.
(Example display readings are
for explanations only; actual dis-
play readings will differ.)
Attention:
Pushing UP and DOWN buttons together for more than two seconds will initate "trial run" or "inspection" mode. Avoid
pushing these buttons simultaneously during normal operation. Push ON / OFF button to cancel trial run or inspection
mode if initiated by accident.
All green lamps turn off when air conditioner is stopped.
Avoid operation of buttons with fingernails or other sharp object. Sharp object may scratch operating panel.
*Heating operation mode is only available for models with built-in electric heater.
Display Panel
Operating panel
TIMER
TEMP
TIMER/TEMP.
12
29
11
28
10
27
9
26
8
25
UP
7
24
6
23
DOWN
5
22
4
21
3
20
2
19
1
18
UP and DOWN buttons
Temperature control (While "TEMP" green lamp is
lit.)
Use UP and DOWN buttons to set desired temper-
o
ature between 18 and 29
C.
Timed operation (While green "TIMER" lamp is lit.)
Use UP and DOWN buttons to set timed operation
between one and twelve hours.
Settings remain in effect until changed. Air
conditioner can be operated by simply pushing
ON/OFF button once settings have been
made.
POWER
ON/OFF
COOL
MODE
DRY
SELECT
FAN
HIGH
FAN
SPEED
LOW
ON
LOUVER
AUTO
STOP
TIMER
MODE
START
MITSUBISHI ELECTRIC
ON / OFF button
Pushing button starts
operation. Pushing again
stops operation. Green
lamp remains lit during
operation.
MODE SELECT button
This button is used to
change between cooling.
ventilation and DRY(or heat-
ing)operation modes.One of
three green lamps light to
indicate mode in effect.
FAN SPEED button
This button is used to
change between low and
high fan speeds. One of
two green lamps lights to
indicade fan speed in
effect.
Swing Louver Button
Used to automatically
disperse airflow vertically.
Air is blown in one
direction when louver is
not turning. Lamp lights
effect.
TIMER MODE button
Used for selecting timed
starting or stopping.Green
lamp light to indicate
timer mode selected.
5

Advertisement

loading