Mitsubishi Electric Mr.SLIM PC-2GJA Technical & Service Manual page 33

OPERATING PROCEDURE
9. Removing the drain pan
(1) Remove the air intake grill.
(2) Remove the beam.
(3) Remove the side panel (right and left).
(4) Remove the under panel. Remove the screws of the right
and left side drain pan.
(5) Remove the insiation in center of the drain pan, and after
removing the screw, remove the drain pan.
(Note)
Please aware that there might be drain left in the drain pan
when you remove the drain pan.
10. Removing the guide vane
(1) Remove the intake grill.
(2) Remove the beam.
(3) Remove the side panel (right and left).
(4) Remove the under panel.
(5) Remove the drain pan.
(6) Remove the screw from the guide vane, then remove the
guide vane.
11. Removing the Auto vane
(1) Remove the intake grill.
(2) Remove the left side panel.
(3) Remove the left side box.
(4) Remove the under panel.
(5) Remove the screw from the auto vane.
(6) Slide the auto vane to the right side and pull the auto vane
out.
PHOTOS&ILLUSTRATIONS
Photo 8
Screw
Drain pan
Screw
(Insulation)
Photo 9
Drain pan
Guide vane
Photo 10
Auto vane
Screw
Screw
Screw
33