Table of Contents
Advertisement
STORAGE
FOLDING THE INVERSION TABLE
The Inversion Stretch System can be easily folded for storage.
To fold the Inversion Stretch System loosen LOCKING KNOB(17) and pull out the SPRING PIN(16).
Now, slide the HEIGHT ADJUSTMENT BEAM(6) all the way up into the MAIN FRAME(4) until the HEEL
HOLDERS(13) are just below the MAIN FRAME(4), release the SPRING PIN(16) and slide the HEIGHT
ADJUSTMENT BEAM(6) slightly up or down until the spring pin locks the beam in place. Remove the
MAIN FRAME ASSEMBLY from the BASE by lifting up on the MAIN FRAME(4) until the PIVOT ARMS(5)
come out of the slots located at the top of the REAR FRAME(2), (Make sure the NYLON STRAP is not
attached to the MAIN FRAME(4) before attempting to remove it.) Push up on the center of the FOLDING
LINKAGES(3) and push the FRONT FRAME(1) and REAR FRAME(2) together until they meet.
MAINTENANCE
The safety level of the Inversion Stretch System can be maintained only if it is examined regularly for
damage and wear.
1.
Check the nylon strap, strap buckle, pivot arms, nylon bed, heel holders, foam pads, and spring pin for
damage and wear.
2.
Replace damaged and worn components immediately and/or keep the equipment out of use until repairs
are complete.
14
Advertisement
Table of Contents
