Figure 7-5. Load Off Screen - Eaton Power Xpert 9395 550/275 Installation And Operation Manual

7.2.7 Load Off Screen
The Load Off screen (Figure 7-5) is displayed when the LOAD OFF pushbutton is selected from the main menu
bar, the UPS Control Command screen, or the Bypass Control Command screen. This screen allows the LOAD
OFF process to be aborted if the LOAD OFF pushbutton was pressed accidentally. For Load Off procedures,
see paragraph 7.3.24 or paragraph 7.4.27.
HOLD LOAD OFF BUTTON FOR 3 SECONDS
CANCEL

Figure 7-5. Load Off Screen

7.2.8 System Status Screen and Controls
Press the CONTROLS pushbutton on the main menu bar to display the System Status screen. Online
operation, transfer to bypass, charger control, UPM startup and shutdown, and LOAD OFF commands are
controlled through this screen. In addition, the screen displays the current status of the UPS, indicates whether
the UPS is in Maintenance Bypass or Bypass, and displays the state of the UPM and battery charger. Figure 7-6
shows the System Status screen.
Use the or pushbutton on the System Status menu bar to highlight the command screen desired, then
press the pushbutton to display the command menu screen.
CONTROLS
Table 7-4 lists the typical System Status Screen Messages that are displayed during UPS operation.
Table 7-5 describes the control functions and provides instructions to access and use the command menu
screens.
For detailed information about using the System Controls, see paragraph 7.3.
TM
Power Xpert 9395 550/275 UPS (225–550 kVA) Installation and Operation Manual 164201716—Rev 8 www.eaton.com/powerquality
TO TURN OFF LOAD
LOAD OFF
UPS Operating Instructions
7-9