Table of Contents
Advertisement
Hot Deli Display Island
Unit Startup and Preheating
BHI
1. Open the access door to the control panel and place the POWER switch in the 1 position.
2. Place THERMOSTAT ZONE knobs 1, 2 and 3 to the number 5 position. The pilot light for each thermostat
will cycle on and off to indicate that proper temperature is being maintained for that zone.
3. Allow the equipment to preheat for 30 minutes before loading it with product.
BHI-T
1. Open the access door to the control panel and place the POWER switch in the 1 position.
2. Place THERMOSTAT ZONE knobs 1, 2 and 3 to the number 5 position. The pilot light for each thermostat
will cycle on and off to indicate that proper temperature is being maintained for that zone.
3. Place THERMOSTAT ZONE knob 4 to the number 5 position. The pilot light for this thermostat will cycle
on and off to indicate that proper temperature is being maintained for the upper shelf.
4. Allow the equipment to preheat for 30 minutes before loading it with product.
Temperature Adjustment
After loading the unit with product, it may be necessary to adjust the thermostat knobs in order to maintain the
proper internal temperature for the product on display. The thermostat knobs should be set to the lowest possible
number that will maintain the proper product temperature.
6
Operation
Advertisement
Table of Contents
