Performance Test Results - Siemens sitrans LU10 Instruction Manual

Performance Test Results

Monitor system performance carefully, under all anticipated operating conditions.
A. When the SITRANS LU10 performs exactly as required, programming is complete.
B. If the SITRANS LU10 measurements are accurate and reliable but alternate
Reading, units, failsafe, LU SAM relay, or LU AO mA output operation is desired,
proceed to Application Parameters.
C. Should system performance not meet installation requirements, (or the "LOE" display
persists after start up), proceed to the
If all operating conditions cannot be observed during the System Performance Evaluation,
Enhancement Parameters
refer to
Measurement simulation to verify programming.
Conduct a System Performance Evaluation following any installation modification or
Quick Start, Application, or Enhancement Parameter alteration.
With programming complete, copy all parameter alterations to the Programming Charts.
In the PROGRAM mode, all altered parameters may be quickly scroll accessed (skipping
by parameters left at preset values).
Connect (or enable) process control / alarm equipment to the SITRANS LU10 only Connect (or enable) process control / alarm equipment to the SITRANS LU10 only Connect (or enable) process control / alarm equipment to the SITRANS LU10 only Connect (or enable) process control / alarm equipment to the SITRANS LU10 only
after satisfactory performance is verified for all possible operating conditions. after satisfactory performance is verified for all possible operating conditions.
after satisfactory performance is verified for all possible operating conditions. after satisfactory performance is verified for all possible operating conditions.
For normal operation, return to the RUN mode. The SITRANS LU10 will perform reliably,
with little or no maintenance.
Page 26
Reading Measurement (P920). Perform a Reading
SITRANS LU10 – INSTRUCTION MANUAL
Troubleshooting Guide
.
7ML19985AN02