Table of Contents
Advertisement
Log Grate Installation
Only use filtered tap water in this appliance.
Once installed, never move this appliance or lay it on its back, without draining the water from the
sump and water tank.
If you intend not using the appliance for longer than 1 week, drain the water from the reservoir and
refill container.
The refill container, reservoir, cover and container cap must be cleaned once every week,
particularly in hard water areas.
1) Fill and install the Refill Container.
Note: During initial installation, the Refill Container shouldd be refilled after the Reservoir has filled
to ensure maximum operation time.
2) Make sure sure the On/Off switch is switched to Off (refer to Operating Instruction section)
3) Assemble power adapter (Figure 2). Plug the power adaptor into the front of the unit, then plug
the unit into a power socket
11
Advertisement
Table of Contents
