Overwriting And Upgrading The Unit Firmware - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
To enable Telnet access to the unit, do the following steps:
1. Click the -remote access link under MANAGEMENT SETTINGS
in the left-hand settings menu.
• The TELNET ACCESS dialog will be shown (see
2. Enable Telnet access by checking the Enable telnet access:
check-box.
3. Save the changed Telnet settings by clicking the Change button.
Alternatively, revert to the old password settings by clicking the
Reset button.

7.7.3. Overwriting and upgrading the unit firmware

The FIRMWARE UPGRADE window contains controls to overwrite the
device firmware of the Cisco FM3200 Endo, or upgrade the firmware to
the latest available version.
To download the needed firmware image file to your computer, do the
following steps:
1. Navigate to
Portal.
2. Find and open the device sub-folder for your specific Fluidmesh
device in the FIRMWARE AND TOOLS folder.
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The Telnet protocol suffers from serious security weaknesses
that limit its usefulness in environments where the network
cannot be fully trusted.
Telnet is used at your own risk.
(page 128) in the previous section).
CAUTION
Overwriting the firmware of any electronic device must be done
with great care, and always contains an element of risk.
It is not advisable to overwrite the firmware on a functioning
Fluidmesh unit unless a specific firmware-related issue needs
to be resolved.
IMPORTANT
To access firmware image files, you need an approved
Fluidmesh extranet account. To create an extranet account,
register for free at the Fluidmesh Partner
the Documentation section of the Fluidmesh Partner
Figure 54
Portal.
Page 129 of 177