Bissell POWERFRESH 2814 Series User Manual page 7

Cleaning Your Hard Floors
NOTE: Before you clean, thoroughly sweep or vacuum floor prior to cleaning
with your PowerFresh® 2-in-1 Multi-Surface Steam Mop. Your hard floor cleaner
is designed to clean hard flooring, such as ceramic tile, marble, stone, and
sealed hard wood floors. Use on waxed or some unwaxed floors may result
in a diminished glossiness. The hard floor cleaner is not for use on unsealed
wood floors. For best results, test in an inconspicuous area and check the
care instructions from your flooring manufacturer.
1
3
When the machine is
plugged in, the Ready
Light will start to blink.
The Ready Light will turn
solid when the machine is
ready to use.
6
NOTE: Upon the first use of your steam mop or first use after refilling the
water tank, the pump may make a "knocking" sound. This is normal and will
diminish after a few seconds.
NOTE: The steam mop generates hot steam, so move the unit continuously
when pressing the trigger as damage to flooring can occur. The trigger does
not need to be pressed at all times.
Attach Mop Pad by
wrapping around bottom
of foot, making sure gray
stitching is located on
the front of foot and the
quick grip release tab is
located on the back.
4
Step on the back of the
foot to recline the body of
machine to begin cleaning.
To be sure to sanitize an area of your floor, use the
microfiber cloth pad and slowly and evenly stroke
your steam mop back and forth at least three
times over the area using continuous steam. For
best results, remove the pad and wash after use.
2
Plug machine into an outlet.
5
Push the trigger on the
handle to release steam.
www.BISSELL.com
7