Table of Contents
Advertisement
EMERGENCY DOOR OPENING
In case of power failure or appliance failure the
appliance door remains locked. The washing
programme continues, when the power is restored.
If the door remains locked in case of failure, it is
possible to open it using the emergency unlock
feature.
Before opening the door:
CAUTION! Make sure that the
water temperature and the
laundry are not hot. Wait till they
cool down, if necessary.
CAUTION! Make sure that the
drum is not rotating. Wait till the
drum stops rotating, if necessary.
Make sure that the water level
inside the drum is not too high.
Proceed with an emergency drain,
if necessary (refer to «Emergency
drain» in «Care and cleaning»
chapter).
TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against
moisture
Water supply pressure
1)
Maximum wash load
Maximum dry load
Spin Speed
1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your do-
mestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the bottom of the water storage tank.
Width/ Height/ Depth/ To-
tal depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Cotton
Synthetics
Maximum
To open the door, proceed as follows:
1. Turn the selector to On/Off position to switch
the appliance off.
2. Disconnect the mains plug from the mains
socket.
3. Open the filter flap.
4. Keep the emergency unlock trigger pulled
downward and, at the same time, open the
appliance door.
5. Take out the laundry and then close the
appliance door.
6. Close the filter flap.
600 mm/ 850 mm/ 605 mm/ 639 mm
230-240 V
2200 W
13 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
8 kg
6 kg
3 kg
1600 rpm
25
Advertisement
Table of Contents
