Can Not Connect To The Network; Leds Work But Can't Connect To Network - Compaq WL110 Quick Install Manual

Can Not Connect To The Network

If your WL110 PC Card seems to be working fine, but you
are not able to connect to the network, this error might be due
to a configuration mismatch.
For example if both LEDs of your WL110 PC Card blink
once every ten seconds, the problem is likely to be caused by
a configuration mismatch of:
Network Name


Encryption Key


The 11 Mbps Wireless LAN Network Name is case-sensitive.

LEDs Work But Can't Connect to Network

If you can not connect to the network while the LEDs
indicate that the network is working properly (Power LED is
on, Radio LED blinks) your problems might be caused by:
Incorrect TCP/IP settings for your wireless network


adapter ("Changing TCP/IP Settings" on page B-7).
Your Windows operating system requires an update with


a Microsoft Service Pack "Install Windows 2000 Service
Pack" on page B-10).
Note: Some older versions of the Windows 95 operating
B-6 Troubleshooting
system will not automatically install the necessary
TCP/IP network protocol.