Figure 7
1. Jam nuts
2. U-bolt
7.
Adjust the nuts
(Figure
rear of the cutting unit so that the tips of the rear
blades are 6 to 10 mm (1/4 to 3/8 inch) higher
than the front tips.
8.
Tighten the jam nuts.
7
Greasing the Cutting Unit
No Parts Required
Procedure
Before operating the cutting unit, it must be greased
to ensure proper lubricating characteristics; refer
to
Greasing the Bearings and Bushings (page
Failure to properly grease the machine will result in
premature failure of critical parts.
All manuals and user guides at all-guidesbox.com
g296783
3. Height-of-cut chain
7) to raise or lower the
17).
Product Overview
Specifications
Note:
Specifications and design are subject to
change without notice.
•
Model No. 31971: 1.52 m (60 inches)
Width
of Cut
•
Model No. 31973: 1.82 m (72 inches)
Height
Adjustable from 25 to 152 mm (1 to 6 inches) in 13
of Cut
mm (1/2 inch) increments
•
Model No. 31971: 209 kg (460 lb)
Net
Weight
•
Model No. 31973: 236 kg (520 lb)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
www.Toro.com
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
11
for a list of all