Table of Contents
Advertisement
All manuals and user guides at all-guides.com
M S-7151 ATX M ainboard
card when system wakes up (resumes) from S3 sleep state. The system
resume time is shortened when you disable the function, but system will need
an AGP driver to initialize the VGA card. Therefore, if the AGP driver of the card
does not support the initialization feature, the display may work abnormally or
not function after resuming from S3. Options: [Auto], [Yes], [No].
Suspend Time Out (M inute)
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings: [Disabled], [1 minute], [2 minutes],
[3 minutes], [4 minutes], [5 minutes], [10 minutes], [15 minutes], [32 minutes],
[64 minutes].
Power Button Function
This feature allows users to configure the Power Button function. Settings
are:
[Power Off]
[Suspend]
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Off]
[On]
[Last State]
Wakeup Event Setup
Press <Enter> and the following sub-menu appears.
Resume From S3 By USB Device
The item allows the activity of the USB device to wake up the system from
S3 (Suspend to RAM) sleep state. Setting options: [Disabled], [Enabled].
3-16
The power button functions as a normal power-on/
-off button.
W hen you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer
is turned off.
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the previous status before
power failure or interrupt occurred.
Advertisement
Table of Contents
