Troubleshooting Fault Codes - Viking Professional 325 Series Use & Care Manual

Troubleshooting/Fault Codes
FLASH
X X
Drain Timeout
X X X X
Fill Timeout
X X X X X X
Flood Sensor Disconnect
X X X X
Temperature Sensor Disconnect
X X X X X X X X
Cycle Error (Motor Control Data Processor)
X X X X
Motor Control Communication Error
X X X X X X
Motor Control Status Error
X X X X
Diverter Error
X X X X X X X X X X
Cycle Error (Error Handler)
X X X X
Pan Flood
X X X X X X
Huba Disconnect
X X X X X X X X
Cycle Error (Circulate)
X X X X
UI-MC Communication Error
X X X X X X
Cycle Error (Fill)
X X X X
Sensor Error
X X
Counter Error (UI)
High Level Error
X X X X
X X X X X X
Cycle Error (Drain)
X X X X
Circulate Timeout (Includes Diverter)
X X
State Error (UI)
X X X X
Cycle Error (Main)
Low Level Error
X X
All manuals and user guides at all-guides.com
FAULT
34
ACTION
1. Turn water on at the sink and run garbage disposal to verify that sink is not clogged.
2. Verify that dishwasher drain hose is not clogged or kinked.
3. If draining into disposal, verify that plug has been removed from disposal.
4. Verify that hose has a high loop, per installation guide.
5. Verify dishwasher is level front to back and side to side.
6. Verify filters are not clogged.
Reset Unit and try again. If problem persists, contact service.
1. Verify water supply to dishwasher is turned on.
2. Verify that fill line is not kinked.
3. Verify that dishwasher is level front to back and side to side.
4. Turn water on at sink and verify there has not been a decrease in water pressure.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
1. Verify that the dishwasher is level front to back and side to side.
2. Verify that drain hose has high loop, per installation guide.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
1. Verify items in rack are properly retained so that they can not turn over.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
Reset Unit and try again. If problem persists, contact service.
1. Verify that no dishes have turned over and are holding a significant amount of water.
2. Verify drain hose has a high loop, per page X in installation guide.
Reset Unit and try again. If problem persists, contact service.
NOTE: To reset unit, press and hold the "START" button for four seconds.
35