Storing The Battery - Toro TimeCutter MX 5075 Operator's Manual

Riding mower
Hide thumbs Also See for TimeCutter MX 5075:
Table of Contents

Advertisement

use an alcohol-based stabilizer (ethanol or
methanol).
B.
Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C.
Shut off the engine, allow it to cool, and
drain the fuel tank using a pump type
syphon or operate engine until it shuts off.
D.
Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
13.
Remove and check the condition of the spark
plug(s); refer to
Servicing the Spark Plug (page
36). With the spark plug(s) removed from the
engine, pour 30 ml (2 tablespoons) of engine
oil into the spark plug hole. Use the starter to
crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install
the wire on the spark plug(s).
14.
Check and tighten all fasteners. Repair or
replace any part that is damaged.
15.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
16.
Store the machine in a clean, dry garage or
storage area. Remove the key from the switch
and keep it out of reach of children or other
unauthorized users. Cover the machine to
protect it and keep it clean.
Do not store fuel containing

Storing the Battery

1.
Fully charge the battery.
2.
Let the battery rest for 24 hours, then check the
battery voltage.
Note:
If the battery voltage is below 12.6 V,
repeat steps
1
3.
Disconnect the cables from the battery.
4.
Check the voltage periodically to ensure that the
voltage is 12.4 V or higher.
Note:
If the battery voltage is below 12.4 V,
repeat steps
1
Battery Storage Tips
Store the battery in a cool, dry area in an upright
position.
Do not stack batteries directly on top of each other,
unless they are in cartons.
Do not stack more than 3 batteries (only 2 if the
battery type is commercial).
Test a wet battery every 4 to 6 months and charge
it, if necessary.
Always test and charge the battery before
installation.
52
and 2.
and 2.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents