Pre-Maintenance Procedures; Raising The Machine; Lubrication; Greasing The Bearings - Toro TimeCutter MX 5075 Operator's Manual

Pre-Maintenance
Procedures

Raising the Machine

Use jackstands to support the machine when you
raise it.
WARNING
Supporting the machine on the lower muffler
shield (Figure 30) may damage the shield and
cause the machine to fall, injuring you or
bystanders.
Do not use the lower muffler shield to support
the machine.
Figure 30
1. Lower muffler shield

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease the caster
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
Note:
Scrape any paint off the front of the
fitting(s).
1. Front caster tire
g299647
4. Connect a grease gun to each fitting
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
31
wheel bearings.
(Figure 31) with a rag.
Figure 31
ARK
g032432
(Figure 31).