Configuring Local Area Network - D-Link DSL-2750U Quick Installation Manual

Wireless adsl2+ router with 3g/lte/ethernet wan support and usb port

Hide thumbs Also See for DSL-2750U:

Table of Contents

DSL-2750U

Configuring Local Area Network

Go to the Net / LAN page. If needed, change the IP address of the

router's LAN interface and the mask of the local subnet in the IP

Address and Netmask fields.

By default, the DHCP server of the router is enabled. In the DHCP

server section, you can change the parameters of the DHCP server. If

you want to manually assign IP addresses to devices of your LAN, disable

the DHCP server (select the Disable value from the Mode drop-down

list).

If you want to use IPv6 addresses in your LAN, specify the relevant

settings. As a rule, it is enough to select the Enable DHCPv6 Server

and DHCP PD checkboxes in the IPv6 DHCP server section.

After specifying the needed parameters on the Net / LAN page, click the

Apply button.

Quick Installation Guide

Table of Contents