Vizio SB3241n-H6 User Manual page 21

Function LED Behavior
Program Remote
Flash from bottom
Learn
Prg Remote
Power LED
PwrLED
AV Delay LED at the bottom
indicates no delay.
AV Delay
Reset Audio or
Reset All
Reset All
Speaker Test
Spkr Test
VIZIO Remote
VZtvRmt
Waiting to learn:
SETUP > PrgRemote > Use the Next/Previous buttons and OK button to toggle and
select and program your TV remote to control the Volume Down, Volume Up, and Mute
functions on your sound bar. See the Programing the Sound Bar on page 20 section for
to top and back
more information.
continuously.
Power LED On
SETUP > PwrLED > Use the Next/Previous buttons and OK button to enable/disable the
Power LED.
Note: Turning the Power LED off also mutes most voice announcements.
Power LED Off
SETUP > AV Delay > Use the Next/Previous buttons to increase/decrease the amount of
audio delay. The LED indicators will move to the top with increasing audio delay level.
SETUP > Reset Audio or Reset All > Use the Next/Previous buttons to reset either Audio
or All settings. Press the OK button to select.
All LEDs will flash
3 times when Audio - Only audio settings, such as bass and treble levels, will be reset.
All - All paired Bluetooth devices will be unpaired and all settings will be lost. All
settings are reset.
programmed IR remotes will also be removed. See the Factory Reset on page 19 for
more information.
SETUP > Spkr Test > OK to activate the speaker test function. A voice will begin calling
out each speaker beginning with left front (Left Front, Right Front, Right Rear, Left Rear,
—
and Subwoofer-white noise). If any of these are missing, check the connection and run the
speaker test function again.
Remote On
SETUP > VZtvRmt > Use the Next/Previous buttons to enable/disable VIZIO TV
Remotes. When enabled (On), you can use a VIZIO TV remote control to turn on the sound
bar (using the TV Volume Up button) and control volume.
Remote Off
Mode & Level Settings
Description
ENG - 17