Table of Contents
Advertisement
There is an excessive
amount of foam in the
drawer for washing
detergent.
Unsatisfactory wash
result.
The water is drained out
of the washing machine
immediately after it has
been fi lled.
No water can be seen in
the drum during the
wash.
There are washing
detergent residues on
the laundry.
There are washing
detergent residues on
the laundry.
Spinning does not take
place or it occurs with
a delay.
(*) See page 18.
(**) See page 4.
(***) See page 6.
Copyright © 201 , Fast ČR, a. s.
You have used a wrong amount of
washing detergent.
Unsuitable washing detergent.
The degree to which your laundry
is soiled does not correspond to
the program you selected.
Insuffi cient amount of washing
detergent.
You exceeded the maximum
recommended laundry load in
the drum.
The end of the drain hose is
too low relative to the washing
machine.
This is not a malfunction.
Water is in a part of the drum that
is not visible.
Residues of the washing
detergent in the form of white
stains may appear on the laundry.
These stains may be caused by oil,
a cream or a lotion.
This is not a malfunction.
The uneven contents testing
system was activated.
Press the Start/Pause button. You can prevent
foam from forming by pouring a mixture of half
a spoon of fabric softener and half a litre of water
into the washing detergent drawer.
Press the Start/Pause button again after
5-10 minutes. When you wash again, use the
correct amount of washing detergent.
Only use washing detergents specially made for
automatic washing machines.
Select a program appropriate for the given degree
to which your laundry is soiled. (More information
in the program chart.)
Use an amount of washing detergent that
corresponds to the level of soiling.
The laundry load in the washing machine should
not exceed the maximum capacity of the washing
machine.
Locate the drain hose at an appropriate height.
(***)
Set your washing machine to start the addition
rinse program or remove the stains using a brush
after the laundry has dried.
During the next wash use the maximum amount
of washing detergent set by its manufacturer.
The uneven load testing system may be trying
to evenly arrange the laundry in the drum. The
spinning process will commence as soon as the
laundry is arranged evenly.
Next time you wash, arrange the laundry evenly
inside the drum.
EN - 2
Advertisement
Table of Contents
