Electrical Connection; Water Supply Connection - Philco PL 1062 CHIVA User Manual

Electrical connection


Technical specifi cations of your washing machine: 220-240 V ~ 50 Hz.

A special grounding plug is attached to the power cord of your washing machine.
This plug must be fully inserted into a grounded power socket (with 10 A). The
fuse or circuit breaker to which the washing machine is connected should be 10 A.
If you do not have such sockets and fuses/circuit breakers at home, have them
installed by a qualifi ed electrician.

Our company takes no responsibility for any damages caused by using the washing
machine without grounding.

Water supply connection


Depending on the functions of your washing machine, the washing machine is equipped with either
a single water inlet (cold) or a double water inlet (cold/hot). The hose with the white end is intended for
the cold water inlet and the hose with the red end is intended for the hot water inlet (on washing machines
with a hot and cold water inlet).

To prevent water from leaking from the connection points, the hose kit also includes 1 seal (for washing
machines with a cold water inlet) or 2 seals (for washing machines with hot and cold water inlets). Install
these seals on the end of the water inlet hose connected to the tap.

Connect the hose with the white end to the water inlet valve with the white fi lter and the hose with the red
end to the water inlet valve with the red fi lter (the second mentioned option applies to washing machines
with a hot and cold water connection). Tighten the plastic connecting parts using your hand. A qualifi ed
plumber will provide a safer connection.

The water pressure of 0.1 - 1 MPa in your water tap will ensure a more effi cient operation of your washing
machine (the pressure of 0.1 MPa equates to a fl ow rate of more than 8 litres of water per minute from
a fully open tap).

After completing all connections, check that the connections do leak, by fully opening the tap.

Check that the supply hoses are not bent, broken or cracked.

Connect the supply hose to a 3/4" threaded water tap.

If the washing machine has a dual water supply (for hot and cold water), the temperature of the hot water
should not exceed 70 °C.
Copyright © 2013, Fast ČR, a. s. Copyright © 201 , Fast ČR, a. s.
3/4"
EN -
05/2013