Pc500Rk Keypad - DSC PC55O Instruction Manual

PC500RK KEYPAD

The "Ready" light will come ON when the
system is ready to be armed. When the
"Ready" light is OFF, there is an open zone
on the system. The zone must be closed or
bypassed before the system can be armed.
The "Armed" light will come
ON to indicate that the system
is armed. The "Armed" light
will FLASH to indicate that
the system is armed and that
there is no Entry Delay on
any of the zones.
The "System" light will come
ON to indicate:
• that zones are bypassed
• there is a trouble condition
on the system
• there are alarms in
memory.
∗
Use the [ ][1][Access Code]
command to display the
zones that have been
bypassed; be sure that zones
are intentionally bypassed
before arming the system.
∗
Use the [ ][2] command to
display any trouble
conditions; be sure to have
trouble conditions corrected
by your installer as soon as
possible.
∗
Use the [ ][3] command to
Important:
Follow the instructions in the manual to test your system weekly. Follow the
guidelines for correcting system trouble conditions; have any system trouble
conditions you cannot correct yourself attended to by your installer.
1
2
3
4
To View Bypassed Zones:
Enter [ ][1][Access Code]. Press [#]
to return to "Ready".
To View Alarm Memory:
Enter [ ][3]. Press [#] to return to "Ready".
To Perform a Bell Test:
Enter [ ][4].
To turn the Door Chime On and Off:
Enter [ ][6].
To program Access Codes:
Enter [ ][5][Master Code] and [number of
code to program] and [new 4-digit code].
Press [#] to return to "Ready".
Test system regularly.
Refer to Instruction Manual
for testing instructions.
F A P
NOT NOT NOT
IN IN IN
USE USE USE
PC500RK
view the alarms in memory.
Press [#]:
• when an error is made in entering an Access
Code, then enter the code again
• to return to "Ready" after using [
[F] Key: Press and hold this key for 2 seconds
to sound an [F] Key alarm
[A] Key: Press and hold this key for 2 seconds
to generate an [A] Key alarm
[P] Key: Press and hold this key for 2 seconds
to generate a [P] Key alarm.
Zone Lights 1 to 4 indicate zone activity. When a
zone is secure, its Zone Light will be OFF; when a
zone is open, its Zone Light will be ON. If a zone
goes into alarm when the system is armed, the
alarm will be indicated on the zone lights until the
system is disarmed.
F A
∗
Ready
Armed
System
Zone 1
Zone 2
Zone 3
Zone 4
P
] commands
7