Subaru FORESTER 2017 Owner's Manual page 62

Press the (Lane Keep Assist) switch once again to turn it off, and "
Assist indicator) is turned off on the EyeSight display area.
The Lane Departure Prevention Function goes into the standby status, and the lane indica-
tor illuminates when all of the following conditions are met.
The vehicle speed is between approximately 40 MPH (65 km/h) and 90 MPH (145 km/h).
The system is detecting the lane markings.
The driver is holding the steering wheel.
When driving on a road that has a lane width that is between approximately 10 ft (3 m)
and 15 ft (4.5 m).
When driving on a straight road or gentle curve.
When driving near the center of a lane.
When the vehicle is about to depart from the lane, Lane Departure Prevention Function
starts to operate and "
operating.
Turned on
E F
miles
If you just lightly put your hands on the steering wheel for a certain period
of time or if you do not operate the steering wheel, the function will auto-
matically be canceled. ("
white again.)
Lane Departure Prevention Function operates when the system deter-
mines that the vehicle will depart from the lane if you continue to drive in
the same manner. Therefore, it operates at an earlier timing than Lane
Departure Warning (
ing environment and road condition).
The lane indicator in the standby status and in operation may illuminate
only on the left side or right side.
" (Lane Keep Assist indicator) illuminates in green while it is
Standby status
E
Lane Keep
Assist
indicator
(white)
NOTE
" (Lane Keep Assist indicator) illuminates in
Refer to page 68) (it may depend on the surround-
F E
(white)
miles
Lane Keep Assist
" (Lane Keep
In operation
F
(green)
miles
S02308
59