Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; Programming The Remote - RCA HD52W66 User Manual

Using the Remote Control
ON•OFF
VCR
DVD AUDIO AUX•HD
MUTE MUTE
BACKLIGHT BACKLIGHT
SKIP SKIP GUIDE GUIDE
OK OK OK OK
MENU MENU
1 1 2
4 4 5
8 8
7 7
INPUT
0 0
REVERSE PLAY PLAY PLA
RECORD RECORD STOP
CC PRESETS CC PRESETS SOUND SOUND
You'll use these buttons for the
Auto Code Search.
Important: The remote may not
be compatible with all models of
all brands of components. It also
may not operate all functions of
the remote that came with your
component.
Tip
To stop the automatic code search without
programming any components, press and hold
CLEAR until the component button on the
remote turns off.
24
Programming the Remote to Operate
Other Components
TV
SA SAT•CABLE SAT•CABLE
The universal remote can be programmed to operate many brands of remote-
controllable VCRs, audio components, DVD players, cable boxes, satellite
FORMAT FORMA FORMAT FORMAT
receivers and other components. In addition to being programmed to operate
your television, it's already programmed to operate most RCA components.
The AUX•HD button can be programmed to operate most brands of an
additional remote-controllable component: satellite receiver, cable box,
GO BACK GO BACK
INFO INFO
DVD, VCR, and an audio component. A second and third RCA TV can be
programmed to any component button, except the TV button.
CLEAR
3 3

Find Out If You Need to Program the Remote

6 6
To determine whether the universal remote needs to be programmed to operate
9 9
one of the components connected to your TV, such as a DVD player, do the
ANT•CAB
following:
FORWARD FORWARD W WARD
1. Turn on the component (in this example, a DVD player).
PAUSE P PAUSE PAUSE
2. Point the remote at the component.
FREEZE FREEZE
3. Press the corresponding component button (in this example, DVD).
4. Press ON•OFF to see if the DVD player responds. If the DVD player

Programming the Remote

There are two ways to program the remote control to operate other
components: Automatic Code Search and Direct Entry.
Using Automatic Code Search
The following instructions can be used to program the remote to operate each
of your components. If you want to stop the automatic code search without
programming any of your components, press the CLEAR button until the
component button you're trying to program turns off.
1. Turn on the component you want to control (VCR, satellite receiver, etc.)
2. Press and hold the button you want to program. While holding the
3. Point the remote at the component, press and release PLAY, then wait five
Note: The TV button can't be programmed on this remote to control any
component; it controls only this TV.
doesn't respond, you need to program the remote to operate it.
Note: The AUX•HD button can only search VCR codes, but can be used for
a non-VCR device by programming it with direct entry method. By default,
the AUX•HD button is programmed for an RCA HDTV Tuner receiver.
component button, press and hold ON•OFF until all of the component
buttons (VCR, TV, DVD, AUDIO, AUX•HD, and SAT•CABLE) flash. Then,
release both buttons.
seconds or until the component button you're trying to program stops
flashing.
Chapter 2