Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; Programming The Remote - RCA HD52W59 User Manual

Using the Remote Control
DVD
AUX•HD TV
Indicator
VOL
MUTE GO BACK
CLEAR
ok
PRESETS
CC INFO
GUIDE
1 2
4 5
7
8
INPUT INPUT
0
REVERSE PLAY
RECORD
STOP
FREEZE SLEEP
You'll use these buttons for the
Auto Code Search.
Important: The remote may not
be compatible with all models of
all brands of components. It also
may not operate all functions of
the remote that came with your
component.
Tip
To stop the automatic code search without
programming any components, press and hold
CLEAR until the indicator on the remote turns
off.
24
Programming the Re mote to Operate
ON•OFF
Other Components
The universal remote can be programmed to operate most brands of remote
CH
controllable components. The remote is already programmed to operate most
RCA components.
MENU
Also, the AUX•HD button can be programmed to operate most brands of an
additional remote-controllable component (such as a VCR, DVD player, satellite
receiver or cable box).
SKIP
3
6

Find Out If You Need to Program the Remote

9
To determine whether the universal remote needs to be programmed to operate
ANTENNA
one of the components connected to your TV, such as a DVD player, do the
FORWARD
following:
PAUSE
1. Turn on the component (in this example, a DVD player).
FORMAT
2. Point the remote at the component.
3. Press the corresponding component button (in this example, the DVD
4. Press ON•OFF to see if the DVD player responds. If the DVD player

Programming the Remote

There are two ways to program the remote control:
•
•
Using Automatic Code Search
The following instructions can be used to program the remote to operate each
of your components. If you want to stop the automatic code search without
programming any of your components, press CLEAR until the indicator on the
remote turns off.
1. Turn on the component you want to operate (VCR, DVD player, etc.)
2. Press and hold the component button you want to program (DVD or
3. Point the remote at the component. Keep the remote pointed at the
Note: The TV button can't be programmed on this remote.
button).
doesn't respond, you need to program the remote to operate it.
automatic code search
direct entry
Note: The AUX•HD button on this remote is set by default to search
for codes for DVD players only. If you want to program it for use with a
different component, use the direct entry method.
AUX•HD). While holding the component button, press and hold ON•OFF
until the indicator on the remote turns on, then release both buttons.
component until the end of this step.
Press and release PLAY, then wait 5 seconds or until the indicator on the
remote stops fl ashing.
Chapter 2