How To Use The Remote After You've Programmed It; Using Direct Entry - RCA HD52W66 User Manual

Important
You must continue pressing the component
button while you enter the code.
Let's say you have a Zenith DVD player. To
program the universal remote to operate the
DVD player, you would:
Press and hold the DVD button while you en-
ter the first code listed for Zenith in the DVD
Codes column.
Release the DVD button. Press ON•OFF to see
if the DVD player responds. If it doesn't, fol-
low the same steps, but enter the second code
for Zenith DVD players instead of the first.
Component Buttons
ON•OFF ON•OFF
VCR
DVD AUDIO AUX•HD
Chapter 2
At this point the remote control is searching for the correct code to
program, so keep pointing it at the component. If, after five seconds, the
component you want to control does not turn off, press and release PLAY
again to tell the remote to search the next set of codes.
Continue pressing and releasing PLAY until the component turns off or until
the all of the component buttons on the remote flash 4 times in unison. If
the component has not turned off by the time all the component buttons on
the remote control flash 4 times in unison, then the remote cannot control
that particular component.
If the component you want to control does turn off:
1. Press and release REVERSE, then wait two seconds. Repeat this step until
the component turns back on.
2. To finish, press and hold STOP until the component button you're trying to
program on the remote control turns off. This saves the code to that button.

Using Direct Entry

1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the code list
at the end of this section.
3. On your remote control, press and hold the component button you want to
program.
4. While pressing the component button, enter a code from the code list. If
all of the component buttons flash 4 times in unison, then the code you've
entered is not the right kind of code for that button (see pages 29-30 to see
which buttons can be programmed to control the component you want).
5. Release the component button, point the remote at the component and
then press ON•OFF to see if the component responds to the remote control
commands. If it doesn't, try pressing the component button and then
ON•OFF (or other buttons on the remote) again.
6. If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote control
commands.
How to Use the Remote After You've
Programmed It
Once the remote has been programmed successfully, you are ready to use it to
TV
operate your components.
To Operate the Component:
SA SAT•CABLE SAT•CABLE
1. Press the appropriate component button (DVD, TV, VCR, SAT•CABLE,
AUDIO, AUX•HD) to set the remote to control the component.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Notes: The remote control may not be compatible with all brands and
models of components.
If you keep pressing buttons and nothing happens, the remote is probably
in the wrong mode. You must press the component button that matches
the component you want to operate (i.e., if you want to operate the VCR,
press VCR on the remote control to put the remote in VCR mode.)
Using the Remote Control
does does turn off:
25