Yamaha XMAX Owner's Manual page 23

SELECT RESET
1
ZAUM1122
1. "RESET" button
4. Release the "RESET" button, and
the oil trip value will reset to zero.
TIP
If the engine oil is changed before the
oil change indicator comes on (i.e. be-
fore the periodic oil change interval has
been reached), the indicator must be
reset after the oil change for the next
periodic oil change to be indicated at
the correct time. To reset the oil
change indicator before the periodic oil
change interval has been reached, fol-
low the above procedure.
The electrical circuit of the indicator
can be checked according to the fol-
lowing procedure.
1. Turn the key to "ON".
2. Check that the oil change indica-
tor comes on for a few seconds
and then goes off.
3. If the oil change indicator does not
come on, have a Yamaha dealer
check the electrical circuit.
V-belt replacement indicator "V-
Belt"
This indicator flashes every 18000 km
(10500 mi) when the V-belt needs to be
replaced. After changing the V-belt, re-
set the V-belt replacement indicator.
Instrument and control functions
To reset the V-belt replacement indi-
cator
1. "TRIP/INFO" switch
2. "RESET" button
1. "RESET" button
TIP
If the V-belt is replaced before the indi-
cator comes on, be sure to reset the V-
belt replacement indicator so that it will
come on at the next correct interval.
3-9
1. Turn the key to "ON".
2. Push the "TRIP" button until "V-
Belt" (V-belt replacement tripme-
ter) is displayed, and then push
the "RESET" button for 3 sec-
onds. The V-belt replacement trip-
meter value will flash.
SELECT RESET
2
1
TRIP
INFO
ZAUM1137
3. Hold the "RESET" button pushed
for 15 to 20 seconds.
SELECT RESET
1
ZAUM1138
4. Release the "RESET" button, and
the V-belt trip value will reset to
zero.
3