Table of Contents
Advertisement
RCU510manual
7/19/01
Trouble Shooting
P R O B L E M
Red light not blinking when you press any key
The remote does not operate
your video devices
Not performing commands properly
Problems programming a TV/VCR
Combo Unit
VCR not recording
Problems changing channels
No response after pressing a key
Flashing Indicator Light
Note: Reprogramming may be required after batteries are removed.
Help Line
If you need additional set-up help, please call the Help Line at:
10:27 AM
Page 17
S O L U T I O N
A) Replace the batteries with 2 new AAA
alkaline batteries.
B) Check if batteries are properly installed.
A) Try all the codes listed for your brand.
B) Try the Code Search method (page 15).
Start Code Search over again to locate
the proper code for full compatibility.
Try the VCR code for your brand. Some
combo units, however, may require both
a TV and a VCR code for full operation.
As a safety feature on your remote, you must
press the REC button twice.
If your original remote required ENTER after
a channel, press ENTER after you select a
channel.
A) Make sure you have new batteries and you
are aiming your remote at your devices.
B) Check that batteries are properly
installed. See page 2.
Invalid Code for the device. Check the Code
list and reprogram the Remote Control.
1-800-420-7968
16
Advertisement
Table of Contents
