Advertisement
RCU1010_US_QS_revA
3/19/03
16:41
Page 8
Delete a SmartMacro
To delete a SmartMacro that has previously been programmed, follow these steps:
1. Press and hold the SETUP key until the touchscreen
shows the Code Setup Mode? Screen. Release the
SETUP key.
2. Press and release the
SETUP
key repeatedly until the
Delete a Macro? Screen appears. Press and release the
LCD OK key.
3. The LCD displays the Delete Macro Key? Screen. Press
and release the LCD MACRO key (1-9) to select the
previously programmed Macro you wish to delete.
4. The LCD touchscreen displays the Confirm To
Delete? Screen. Press and release the OK key on
the touchscreen.
If you are in the process of deleting a SmartMacro
Note:
and you decide not to delete it, you can abort the
deletion process by pressing the LCD EXIT key.
5. If there are additional Macros already programmed,
the touchscreen displays the Delete a Macro? Screen
again. You may delete additional macros at this point,
if you wish.
6. If there are no previously programmed Macros, the
touchscreen displays the Set a Smart Macro? Screen.
7. The Macro deletion is now complete. To exit the Setup
Mode, press and release the EXIT key, followed by the
LCD OK key on the Exit Setup Screen.
Restoring Original Settings
Master Reset
A Master Reset returns all the RCU1010 defaults to the original factory settings. The Master Reset
clears all customer-programmed codes, Learned commands and SmartMacros, and resets all key labels.
To perform a Master Reset, follow these steps:
1. Press and hold the SETUP key until the touchscreen
shows the Code Setup Mode? Screen. Release the
SETUP key.
2. Press and release the SETUP key repeatedly until the
Reset ALL? Screen appears.
3. Press and release the LCD OK key.
4. The LCD displays the Confirm to Reset? Screen. Press
and release the LCD OK key. The Please Wait Screen
appears and the LCD touchscreen turns off.
5. All settings are now reset to the factory default.
RCU1010 US IB Quickstart Guide RevA
Advertisement
