Using The Receiver To Play Dvd; Using The Receiver To Play Cd; Using The Receiver To Play Video Cassette; Using The Remote To Control Additional - RCA RT2300 User Manual

RT2300-rev.1 7/27/99 7:01 PM Page 15
How to Operate your Receiver
Using the Receiver to Play
DVD
After you have connected your DVD player and
receiver, you can partly control the DVD play through
your receiver:
1. Connect the DVD player with the receiver and
other components. (For more details please refer to
page 4.)
2. Turn on the receiver.
3. Select DVD.
4. Turn on DVD player and play DVD through your
DVD player.
5. Press and rotate Multi Jog to select input signal –
Optical or Coaxial. (For more information refer to
item 6 "Multi Jog" on page 9.)
6. Set Night Mode if needed. (For more information
refer to section "Night Mode" on page 14.)
7. Change Volume.

Using the Receiver to Play CD

After you have connected your CD player and
receiver, you can partly control the CD play through
your receiver:
1. Connect the CD player with the receiver. (For more
details please refer to page 4.)
2. Turn on the receiver.
3. Select CD.
4. Turn on CD Player and play CD through your CD
player.
5. Press and rotate Multi-Jog to select input signal –
Optical or Analog. (For more information refer to
item 6 "Multi Jog" on page 9.)
6. Change Volume.
7. Set Preset EQ if needed. (For more information
refer to item 11 "Preset EQ" on page 9.)
8. Set Surround Mode if needed. (For more
information refer to section "The Test Tone / Setup
button" on page 13.)
Using the Receiver to Play
Video Cassette
After you have connected your VCR and receiver, you
can partly control the VCR playback through your
receiver:
1. Connect the VCR with the receiver. (For more
details please refer to page 4.)
2. Turn on the receiver.
3. Select VCR1.
4. Turn on VCR and start play CD on VCR.
5. Press and rotate Multi-Jog to select input signal –
Analog only. (For more information refer to item 6
"Multi Jog" on page 9.)
6. Change Volume.
7. Set Preset EQ if needed. (For more information
refer to item 11 "Preset EQ" on page 9.)
8. Set Surround Mode if needed. (For more
information refer to section "The Test Tone / Setup
button" on page 13.)
Using the Remote to Control
additional components
You can set your remote to control components other
than the receiver itself (like CD, TV, DVD, TAPE, etc.).
What you need is to program your remote to control
them in advance:
1. Turn on the component to be programmed.
2. Look up the brand and corresponding code
number in the code list on page 16.
3. While keeping the component button (like VCR1,
VCR2, TV, DVD) on the remote pressed, enter the
code from the code list.
4. Release the component button, then press POWER
to see if the component responds to the remote
commands. If it doesn't work, try pressing the
component button, then POWER again.
5. Repeat steps 3 through 4 using the next code listed
for the brand of your component until the
component responds to the remote commands.
This remote may not operate all models of the brands shown.
If a battery is removed from the battery compartment of the
remote control, all control key functions will return to
original, and you need to re-enter all previous programmed
codes again.
The buttons on the remote operate may not work on all other
brands of components. Experiment with the remote and your
components to see which buttons work. If only a few
functions operate, check to see if another code set will work
with more buttons.
GB
12