Table of Contents
Advertisement
en Disposal
Fault
The wireless cooking
sensor display does
not light up.
The display on the
sensor flashes twice.
The display on the
sensor flashes three
times.
/
/
The cooking zones
do not heat up, and
is displayed.
24.3 Normal noises from your appliance
An induction hob may sometimes cause noises or vi-
brations, such as buzzing, crackling, hissing noises, fan
noises or rhythmic noises.
25 Disposal
25.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
▶
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
26
Cause and troubleshooting
The cooking sensor has overheated and the cooking zone has been switched off.
▶
Wait until the cooking sensor has cooled down sufficiently before activating the function
again.
The cooking sensor has overheated and all of the cooking zones have been switched off.
▶
When you are not using the cooking sensor, remove it from the cookware and keep it
away from other cooking zones or heat sources. Switch on the cooking zones.
The battery in the cooking sensor is almost flat. The next time you cook, you may be inter-
rupted by the battery running out.
▶
Replace the 3 V CR2032 battery. For more information, see the section entitled
→ "Replacing the battery", Page 18
The connection to the cooking sensor has been broken.
▶
Switch off the function and reactivate it.
The cooking sensor is broken/faulty.
▶
Contact the technical after-sales service.
The wireless cooking sensor is not responding and the display does not light up.
▶
Replace the 3 V CR2032 battery. For more information, see the section entitled
→ "Replacing the battery", Page 18.
▶
If this does not solve the problem, press and hold the symbol on the cooking sensor for
8–10 seconds and then reconnect the cooking sensor to the hob. You can find more in-
formation in the section entitled
→ "Connecting the wireless cooking sensor", Page 16.
▶
If the problem persists, contact our technical after-sales service.
The battery in the cooking sensor is almost flat. The next time you cook, you may be inter-
rupted by the battery running out.
▶
Replace the 3 V CR2032 battery. For more information, see the section entitled
→ "Replacing the battery", Page 18.
The connection to the cooking sensor has been broken.
▶
Press and hold the symbol on the cooking sensor for 8–10 seconds and then reconnect
the cooking sensor to the hob.
The operating voltage is incorrect and outside of the normal operating range.
▶
Contact your energy supplier.
The hob is not connected correctly.
▶
Disconnect the hob from the mains. Connect the hob in accordance with the circuit dia-
gram.
Demo mode is activated.
1.
Disconnect the hob from the mains and, after a few seconds, reconnect it.
2.
Deactivate demo mode in the basic settings within the next three minutes.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Advertisement
Table of Contents
