Table of Contents
Advertisement
An alarm will sound for ten
seconds when the flow
reaches the set level.
And the hot water will stop automatically.
Turn off the hot
6
water when the
alarm sounds.
The alarm will sound when
the set level has been
reached. Stop the water.
The setting temperature becomes the bath fill temperature after the bath fill was used.
If the bath fill is being used to indicate when a bath is full:
• If any hot water is being used besides what is going into the bath, the alarm will sound before
the bath is full.
• If there was water in the bath before the fill began, the bath may overflow.
• If there was water in the bath before the fill began, the temperature in the bath after it is full
may be different from the temperature setting.
22
Operating Instructions
* When using hot water at another hot water outlet, also
turn it off.
<When you turn off the hot water supply>
• Bath fill temperature indicator turns off. (within approx. 30
seconds).
<If you do not turn off the hot water supply>
The equipment automatically runs the water to check if the hot
water supply has been turned off.
<When approx. 10 minutes passes without turning off the
hot water supply the sound is played>
The following screen appears, so turn off all the hot water
supplies and then press the buth fill button.
* Do not open the hot water supply until the Bath fill temperature
indicator goes off.
Advertisement
Table of Contents
