RCA CC615 User Manual page 52

Playback
Playback on a TV Without Audio/Video Inputs
To connect your camcorder to a TV without audio/video inputs, you will need an
optional 1CVA147C RF output adapter and an optional coaxial RF cable, such as
AH065G or AH066G shown on page 54. If your TV has AUDIO and VIDEO IN jacks
(or is connected to a VCR), refer to pages 48-49.
VHF Antenna
Optional Coaxial
RF Cable
1
(such as AH065G or AH066G)
OR
OR
Optional
Transformer
(Such as 193983)
IN FROM ANT
Connector
CH3/CH4
Installation
1 Disconnect the VHF antenna from
your TV. Connect the antenna to the
IN FROM ANT connector on the RF
output adapter if you are going to leave
the adapter connected to the TV.
Note: If your VHF antenna is the flat
twin-lead type attached by two screws,
you will also need an optional 300/75 ohm
transformer, such as 193983 shown on
page 54.
50
Back of TV
2
VHF
OR
Optional
Transformer
(Such as AH011) VHF
2
OUT TO TV
Connector
VCR/TV
Switch
Optional RF Output Adapter
Switch
(1CVA147C)
2 Attach one end of the optional coaxial
3 Attach the RF output adapter's plug to
AUDIO, RF DC
3
OUT, VIDEO
RF Output
Adapter's Plug
RF cable to the OUT TO TV connector
on the adapter, and attach the other end
to the VHF input on your TV as
shown.
Note: If your TV has 300 ohm screw
terminals, you will need a 75/300 ohm
transformer, such as AH011, shown on
page 54.
the AUDIO, RF DC OUT, and VIDEO
jacks located under the small cover on
the back of the camcorder.
Jacks