Table of Contents
Advertisement
What to Do
Complete the following steps to mount the NI 9154 on a DIN rail.
1.
Align the NI 9154 and the DIN rail clip.
2.
Fasten the DIN rail kit to the NI 9154 using the screwdriver and M4x22 screws. NI
provides these screws with the DIN rail mounting kit. Tighten the screws to a maximum
torque of 1.3 N · m (11.5 lb · in.).
Note
because they are the correct depth and thread for the DIN rail clip.
Clipping the Device on a DIN Rail
Complete the following steps to clip the NI 9154 on a DIN rail.
1.
Insert one edge of the DIN rail into the deeper opening of the DIN rail clip.
2.
Press down firmly to compress the spring until the clip locks in place on the DIN rail.
Caution
from the DIN rail.
Mounting the Device on a Panel
You can use the NI panel mounting kit to mount the NI 9154 on a panel.
10 | ni.com | NI 9154 User Manual
You must use the screws provided with the NI DIN rail mounting kit
2
Ensure that no C Series modules are in the NI 9154 before removing it
1
Advertisement
Table of Contents
