English - IKEA LAGAN Manual

6
Product description
12
11
First use
1. Make sure the water supply is perfectly clean and water inlet and outlet are well connected.
2. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener.
3. Fill the salt container and rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing residuals that can still be inside the appliance. Do not use detergent and do not load the baskets.
After starting a programme, it may take up to 5 minutes for the appliance to recharge the resin in the water softener. It seems that the
appliance is not working. The washing phase starts only after this procedure is completed. The procedure is repeated periodically.
If the interior of the appliance is wet. This is not a defect of the appliance. It is caused by the himidity in the air that condense
on the wall.
Fill in the salt container
1
2
4
Caution! Use rough salt designed for dishwashers only. Fine salt
increase the risk of corrosion. The salt is used to recharge the resin
in the water softener and to assure good washing results in daily
use.
Caution! Water and salt may come out of the salt container when
you fill it. After you fill the salt container, immediately start a
programme to prevent corrosion.
10
1
1
2
2
3
3
4
4
5
6
Fill in the rinse aid & detegent dispenser
1
3 3
5
5
6
To download the full version visit www.ikea.com
9 8 7 6
Lower spray arm 7 Cup shelf
Filters 8 Upper basket
Rinse aid dispenser 9 Cutlery rack
10
Rating plate Cutlery basket
11
Lower basket Detergent dispenser
12
Upper spray arm Salt container
2
6
7

ENGLISH

5
3