Details On The Control Circuit Terminals Of The Converter Unit (Fr-Cc2) - Mitsubishi Electric FR-A802-E Instruction Manual

 Communication
Terminal
Type Terminal name
symbol
— Ethernet connector
— PU connector
USB A connector
—
USB B connector
 Safety stop signal
Terminal
Terminal name
symbol
Safety stop input
S1
(Channel 1)
Safety stop input
S2
(Channel 2)
Safety stop input
SIC
terminal common
Safety monitor
So (SO) output (open
collector output)
Safety monitor
SOC output terminal
common
2.6.2 Details on the control circuit terminals of the
converter unit (FR-CC2).
For the parameter details, refer to the FR-CC2 Instruction Manual.
Communication can be made via Ethernet.
Category: 100BASE-TX/10BASE-T
Data transmission speed: 100 Mbps (100BASE-TX) / 10 Mbps (10BASE-T)
Transmission method: Baseband
Maximum segment length: 100 m between the hub and the inverter
Number of cascade connection stages: Up to 2 (100BASE-TX) / up to 4 (10BASE-T)
Interface: RJ-45
Number of interfaces available: 1
IP version: IPv4
RS-485 communication can be made through the PU connector (For connection on a 1:1 basis
only)
Conforming standard: EIA-485 (RS-485)
Transmission format: Multidrop link
Communication speed: 4800 to 115200 bps
Wiring length: 500 m
A connector (receptacle).
Plug a USB memory device into this
connector to copy parameter settings or use
the trace function.
Mini B connector (receptacle).
By connecting the inverter to a personal
computer via this connector, FR
Configurator2 installed on the computer can
be used for setting the inverter, or monitoring
or testing the inverter operation.
Terminal function description
Use terminals S1 and S2 to receive the safety stop signal input
from the safety relay module. Terminals S1 and S2 can be used
at a time (dual channel).
The Inverter judges the condition of the internal safety circuit from
the status (shorted/opened) between terminals S1 and SIC, or
between S2 and SIC. When the status is opened, the inverter
output is shut off.
In the initial status, terminal S1 and S2 are shorted with terminal
PC by shorting wires. Terminal SIC is shorted with terminal SD.
Remove the shorting wires and connect the safety relay module
when using the safety stop function.
Common terminal for terminals S1 and S2.
The output status varies depending on the input status of the
safety stop signals.
The output is in HIGH state during occurrence of the internal
safety circuit failure. The output is in LOW state otherwise.
(The open collector transistor is ON (conductive) in LOW state.
The transistor is OFF (not conductive) in HIGH state.)
Refer to the Safety Stop Function Instruction Manual if the output
becomes in HIGH state even though both terminals S1 and S2
are open. (Contact your sales representative for this manual.)
Common terminal for terminal So (SO).
Terminal function description
Interface: conforms to USB 1.1 (USB 2.0 full-
speed compatible)
Transmission speed: 12 Mbps
Rated specification
Input resistance: 4.7 kΩ,
input current: 4 to 6
mADC (with 24 VDC
input)
—
Permissible load: 24
VDC (27 VDC at
maximum), 0.1 A
(The voltage drop is 3.4
V at maximum while the
signal is ON.)
—
2. INSTALLATION AND WIRING
1
2
3
4
5
6
7
8
Refer to
page
9
10
58
47
2.6 Control circuit