Gravely Pro-Turn 152 CARB Owner's/Operator's Manual page 29

4. Loosen tie rod jam nuts and turn tie rod
until steering levers are aligned.
5. Tighten jam nut on tie rod, tighten brake
interlock.
4
1
1. Tie-Rod Jam Nut
2. Tie-Rod
3. Steering Lever
4. Brake Interlock
5. Hydrostatic Transmission
Figure 15
ADJUSTING THE UNIT TO TRACK
STRAIGHT
(Figure 16)
WARNING: Prior to adjusting the
tracking of the unit, shut OFF engine,
engage parking brake, and remove
the ignition key.
Check and adjust tire pressure. Increase
pressure on side unit tracks to. DO NOT
exceed maximum recommended tire
pressure (See SPECIFICATIONS on
page 38).
If tire pressure adjustment does not solve
tracking problem, adjust the limiter bolts on
the stop bracket (Figure 16). Front bolts
adjust forward and rear bolts adjust reverse.
Lengthen the limiter bolt (move closer to
lever) on side which is too fast.
3
1
2
ADJUSTING THE HEIGHT OF THE
STEERING LEVER HANDLES
(Figure 17)
NOTE: Align handlebars by adjusting
eccentric spacer until the handlebar height is
5
the same.
EN - 29
1
2
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
Figure 16
1. Remove mounting hardware and move
handlebar up or down until the steering
levers are at the appropriate height.
2. Install mounting hardware.
1
4
3
1. Handle
2. Eccentric Spacer
3. Steering Lever
4. Mounting Hardware
Figure 17
3
2
1
4
2