Table of Contents
Advertisement
Display/Problem
flashes
appears
flashes
and
appears or the monitor
is turned off
unexpectedly during a
measurement.
Nothing appears on the
display of the monitor.
Possible Cause
There are more than
24 readings in memory to
be transferred.
Your monitor is not paired or
not connected with the
receiver.
There are 30 readings in
memory to be transferred.
Batteries are low.
Batteries are depleted.
Batteries are depleted.
Battery polarities are not
properly aligned.
30
Solution
Pair or transfer your
readings to the receiver so
you can keep them in
memory in the receiver,
and this error symbol
disappears.
Replacing all 4 batteries
with new ones is
recommended. Refer to
sub-section 2.1.
Immediately replace all
4 batteries with new ones.
Refer to sub-section 2.1.
Check the battery
installation for proper
placement. Refer to sub-
section 2.1.
Advertisement
Table of Contents
