Sound Problems - LG CineBeam HF65LA Owner's Manual

112

Sound Problems

First of all, perform a
any abnormalities in the projector.
If you are using a set-top box, turn it off, and then turn it back on.
Make sure that the set-top box is correctly connected to your projector.
The screen is fine, but it does not play any sound.
•
Try another channel.
• (Q. Settings)
Check whether the [Sound Out] is set to [Internal Projector Speaker].
If you use a set-top box, there will be no sound if you have set the volume of
the set-top box or your projector to 0 or enabled Mute. Set the volume to an
appropriate level.
The stereo sound is not clear on an analog channel, or there is no sound from
one of the speakers.
•
Applies only in countries where sound multiplex broadcasting is available.
Wheel (OK) or
Select [MONO] in Multi Audio if you are out of range or sound multiplex
broadcasting is not stable.
• (Q. Settings)
Adjust the balance as necessary with the Navigation button in [Balance].
The TV sound is not synchronized with the picture, or the sound sometimes
breaks up.
• If this happens on only some of the channels, it may be caused by the
broadcasting company's transmission signal. Please have your broadcasting
services provider (wired/cable) diagnose the problem.
• If all channels are out of sync, go to
Sync Adjustment] and adjust the sync.
(Q. Settings)
[Sound] [Sound Out]
OK
[Sound] [Sound Mode Settings]
(Q. Settings)
[Sound] [Sound Test] to check for
[Sound]
[Balance]
[AV