Weber SUMMIT S-620 Owner's Manual page 12

Check
A) Bulkhead and gas supply hose connection (1) .
B) Bulkhead to regulator connection (2) .
C) Regulator to hose connection (3) .
D) Main gas line to manifold connections (4) .
E) Side burner hose to bulkhead connection (5) .
m WARNING: If there is a leak at connection (1, 2, 3, 4, or 5),
retighten the fitting with a wrench and recheck for leaks with
soap and water solution. If a leak persists after re-tightening
the fitting, turn off the gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your area
using the contact information on our web site. Log onto
www.weber.com.
F) Side burner hose to quick disconnect connection, side burner valve and orifice
connections (6) .
G) Hose to quick disconnect connection (7) .
H) Valves to manifold connections (8) .
m WARNING: If there is a leak at connections (6, 7, or 8), turn
off the gas. DO NOT OPERATE THE GRILL. Contact the
Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com.
When leak checks are complete, turn gas supply off at the source and rinse connections
with water .
Reinstall Control Panel
A) To reinstall the control panel assembly, reverse steps for "Remove Control Panel"
as previously described .
m WARNING: Make sure that all parts are assembled and
hardware is fully tightened before operating the grill. Your
actions, if you fail to follow this product warning, may cause
a fire, an explosion, or structural failure resulting in serious
personal injury or death as well as damage to property.
12
GAS INSTRUCTIONS
◆
8
1
2
3
6
The grills illustrated in this
Owner's Guide may vary slightly
from the model purchased .
4
5
7