Philips EVNIA 42M2N8900/00 User Manual page 25

Compulsory execution message
To reduce the risk of image retention, Panel Refresh will
automatically run after in use for a long periods of time.
Panel Refresh will take few seconds and power LED will blink
until it is �nished.
Please do not unplug the power cable during the process.
Proceed
• Auto Warning
Default setting is On to provide
messages as reminders of Pixel Refresh
and Panel Refresh automatically. If you
turn off Auto Warning, the messages
will not appear, yet the calculation
of cumulative usage hours continues.
If Auto Warning is set to Off, the
cumulative usage exceeds 16 hours, Pixel
Refresh will be activated automatically
when you press the power button or the
monitor goes into Standby mode.
A reminder message that pops up after 4 hours of
continuous use, and will then appear every 2 hours
after.
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 4HOURS
Do you want to activate Pixel Refresh now?
Yes
Note
1. Pixel Refresh and Panel Refresh
can be run whenever you detect a
luminance gap or image sticking.
2. While the display is in standby mode,
refresh will run automatically when
needed. This will ensure your display
offers the best possible performance
while minimizing interruptions.
No
LED Indicator
Status
Power On
Standby
Pixel Refresh
Panel Refresh
Panel Error
Power Off
23
LED Color
White
White (breathing)
White (blinking)
Amber (blinking)
Amber
No LED