Steps
1. Place and slide the hard drive into the hard-drive bracket.
2. Align the screw holes on the hard drive bracket with the screw holes on the hard drive.
3. Replace the four (M3x3) screws that secure the hard drive to the hard drive bracket.
4. Connect the hard drive cable to the hard drive assembly.
5. Place the hard drive assembly on the palm-rest and keyboard assembly.
6. Align the screw holes on the hard drive assembly to the screw holes on the palm-rest and keyboard assembly.
7. Replace the four (M2x3.5) screws that secure the hard drive assembly to the palm-rest and keyboard assembly.
8. Connect the hard drive cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
The following images indicate the location of the memory modules and provide a visual representation of the removal procedure.
46
Removing and installing components
After working inside your
Before working inside your
computer.
computer.