Polaris GENERAL 1000 2017 Owner's Manual For Maintenance And Safety page 24

FEATURES AND CONTROLS
Console
Gear Selector
Low gear is the primary driving range for your
vehicle. High gear is intended for use on hard-
packed surfaces with light loads. Using high
gear for heavy loads, hilly terrain or in wet,
muddy conditions will increase the chance of
drive belt burning. See the Drive Belt Wear/
Burn section on page 93.
H: High Gear
L: Low Gear
N: Neutral
R: Reverse
P: Park
To shift gears, brake to a complete stop. When the engine is idling, move the lever to the
desired gear.
NOTICE: Shifting gears with the engine speed above idle or while the vehicle is moving could cause
transmission damage. Always shift when the vehicle is stationary and the engine is at idle.
Tip: Maintaining shift linkage adjustment is important to assure proper transmission function. Your
POLARIS dealer can assist in resolving any shifting problems.
Using Low Range
Always shift into low gear for any of the following conditions.
• Operating in rough terrain or over obstacles
• Loading the vehicle onto a trailer
• Towing loads
• Driving frequently at low RPM or at ground speeds below 7 MPH (11 km/h)
Switches
Ignition Switch
The ignition switch is a three-position, key-operated
switch. The key can be removed from the switch when
it is in the OFF position.
OFF The engine is off. Electrical circuits are off,
except Acc, 12V.
ACCESSORY The engine is off. Powers the gauge and
(if equipped) terminal block. Check engine and steering
warning indicators will appear on the
gauge in this mode, but will turn off when
the vehicle is started if no issues are
present.
ON Electrical circuits are on. Electrical
equipment can be used.
START Turn the key to the START position to
engage the electric starter. The key
returns to the ON position when released.
22
Gear Selector (Shifter)
Ignition Switch