Table of Contents
Advertisement
We know wiring is hard. Let's make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch
setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualifi ed electrician.
Hunter Pro Tip:
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
WARNING
The ceiling fan must be grounded. If the
ground wire for the installation site is not
present, immediately STOP installation and
consult a quali ed electrician.
Connect the black
(ungrounded) wire from
the ceiling to the black
wire from the receiver.
Connect the white (grounded)
wire from the ceiling to both
the white wire from the
receiver and the white wire
from the fan.
x4
bag
Wire Nut
Note:
Fan style may vary.
Ceiling Bracket
Downrod
Wiring the Fan
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a quali ed electrician.
White
Hanging Fan
Wiring
Slide the remote
receiver onto the
top of the bracket.
Hunter Pro Tip:
Have extra wiring?
Turn the wires upward and push them carefully
back through the hanger bracket into the outlet
box. Spread the wires apart, with the grounded
wires on one side of the outlet box and the
ungrounded wires on the other side of the outlet
box. Make sure that the wires are still attached
to the wire nuts.
Connect the yellow
wire from the
receiver to the black
wire from the fan.
Connect the blue wire
from the receiver to the
blue wire from the fan.
Canopy
Blades
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling, downrod, and
hanging bracket.
DR19-01 r091420
6
Light
Control
1886
Advertisement
Table of Contents
