Installing The Canopy - Hunter 50008 Installation Manual

1886
IMPORTANT
NOTE: Make sure blade iron is installed to the right
holes. Installing it incorrectly could result in your fan
not functioning.
7
Ceiling Bracket Downrod

Installing the Canopy

Lift the canopy into place so that
the screw holes are aligned.
Installing the Blade Iron
Hanging Fan Wiring
Insert the two canopy screws
found in the hardware bag.
There are five pairs of holes in the fan. Lift the blade
iron into position. Align the grommeted holes in the
blade iron with the holes on the fan. It does not matter
which hole you choose. Install the blade iron screws
found in the hardware bag to secure the blade iron to
the fan.
Canopy Blades
x2
Canopy Screw
bag
NOTICE
If screw holes do not align
properly then rotate the canopy
180 degrees. Hanger ball shape
must match canopy opening for
correct canopy installation.
x5
bag
Blade Iron Screw
Light Remote Troubleshooting