Amplifier Setup; Configuration Memories - QSC RAVE 520az Hardware Manual

General Information & Configuration Memories

Amplifier Setup

Amplifiers connected to the system must have their power switches in the "on" position. For initial testing, use the lowest useful gain
setting until the system is operating as expected. After the system setup has been verified and tested, gain settings may be adjusted as
required.
Network
The network should be operable and QSControl.net software should be installed/running on the system controller computer.
CobraNet Connection Loss
If you are operating with a valid CobraNet network, and the connection to the network is disrupted, audio will momentarily mute, allow-
ing the RAVE 520az to synchronize with its internal clock. If CobraNet network connection is re-established, the audio will mute again
while the RAVE 520az synchronizes with CobraNet.

Configuration Memories

The RAVE 520az has non-volatile storage locations that contain settings for the device as well as DSP signal flow. The storage loca-
tions make it possible to set up the RAVE for different situations and quickly recall the setup with or without QSControl.net software
using the front panel controls.
13