Operation; Remote Control - Friedrich CCF05B10A Service Manual

Remote Control

1
3
9
8
7
9. MONEY SAVER: When the unit is in COOL mode, press the button to MONEY SAVER function. In MONEY SAVER mode, the unit will
turn off once the room is cooled to the user set temperature. The unit will turn back on when the room temperature rises above the
user set temperature. Before the compressor starts, the fan motor will run for 20 sec., then it will stop for 10 min., and will repeat to
provide a much more comfortable feeling and save energy.
Battery size: AAA
Note: Do not mix old and new batteries or different types of AAA batteries.
11

OPERATION

1. Power: Turn the air conditioner on and off. This button will clear the TIMER setting.
2. MODE: Press the button to select the mode of operation, AUTO, COOL, DRY, FAN ONLY, HEAT.
Note: The HEAT mode is only for some heating models. If you do not need it, press the MODE
button for more than 5 seconds to delete the HEAT function, and the COOL mode will be selected
automatically. Press the MODE again for more than 5 seconds to add the HEAT function, and the
HEAT mode will be selected automatically.
3. + And - : Use these buttons to increase or decrease the setting Temperature or Timer.
Setting temperature range: 61 ~88°F or 16 ~31°C .
Note: After setting temperature with remote using th + and - buttons, both the remote
display and the unit display will automatically turn off after a short time. This does not
affect the unit operation.
4. TURBO: When the remote is ON, press the button to activate the TURBO function,
under AUTO/COOL/FAN ONLY mode. Press again to cancel the TURBO function, and the
2
fan speed will change to pre-setting before.
Note: °F and °Cchange: After inserting the batteries, in the off state within 3 minutes,
press the TURBO button for more than 5 seconds to switch the Fahrenheit (°F) or
3
Celsius (°C) degree display.
5. DISPLAY: When the unit is ON, press the button, to switch off/on all lights or LED
4
display. And this function will be canceled when changing mode.
6. TIMER: Use the button to set the TIMER, or cancel the TIMER.
5
TIMER OFF: When the unit is ON, the timed OFF is programmed by pressing TIMER
button, the remote will display 6 hours pre-setting at first.
6
Set the rest time by pressing the button or until the needed rest time display, then press
TIMER button again to confirm.
TIMER ON: When the unit is OFF, the timed ON is programmed by pressing TIMER
button, the remote will display 6 hours pre-setting at first. Set the rest time by pressing
the button or until the needed rest time display, then press TIMER button again to
confirm. Later, the remote screen will keep display [TIMER] icon.
Note: When TIMER ON, it cannot select Sleep mode, but can pre-set Mode, temperature,
fan speed, ECO.
7. SLEEP: Press the SLEEP button, all of the display lights will turn off after a while, but
the Sleep light is always on. In SLEEP mode, the air conditioner will automatically adjust
the temperature and fan speed to make the room more comfortable during the night.
The set temperature will automatically raise every 30-60 minutes and at most change
six times until the set temperature is 81 or 82°F. This function can be selected when
COOL or HEAT mode.
8. FAN SPEED: Press the FAN SPEED button to choose the fan speed options. You can
choose Hi, Med, Lo or Auto speed in COOL or HEAT mode and choose Hi, Med, Lo in FAN
mode. When DRY mode, it is only Low fan speed.
Figure 301 (Remote Control Operation)