Operation; Air Flow Selection And Adjustment - Friedrich ZoneAire Premier R-32 Series Service Manual

Air Flow Selection and Adjustment

VENTILATION CONTROL
The ventilation control lever is located at left
side of unit, behind front panel.
NOTE:The vent door shipping hardware must
be removed before using vent control lever.
See Installation Instructions.
When set at close POSITION, only the air inside
the room is circulated and filtered.
When set at open POSITION, some outdoor
air will be drawn into room. This will reduce
heating or cooling efficiency.
EnergyTip : Keep the vent control at POSITION.
Room air will be filtered and circulated.
ADJUSTING AIR DIRECTION
To adjust air direction:
1.Remove front panel.
2.Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. J.2.2
3. Turn louver insert and rotate 180 See Fig. J.2.3
4.Replace louver insert.
5.Replace screws and front panel.
Figure J.2.2 (Backside of Front Panel)
Air discharge upward
15

OPERATION

Open position
Vent Control
(Pull lever through label
Louver screws
Figure J.2.3 (Adjusting Louvers)
Close position
to operate.)
Figure J.2.1 (Ventilation Control Location)
Air discharge outward (Default)