Table of Contents
Advertisement
Touch recessed sensor surface : on the
X
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
Make sure you only touch recessed sensor
surface :.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with power
tilt/sliding panel are closed.
Vehicles with panorama roof with power
X
tilt/sliding panel: touch recessed sensor
surface : on the door handle again until the
roller sunblinds of the panorama roof with
power tilt/sliding panel close.
To interrupt convenience closing:release
X
recessed sensor surface : on the door han-
dle.
Problems with the side windows
G
WARNING
If you close a side window again immediately after it has been blocked or reset, the side window
closes with increased or maximum force. The reversing feature is then not active. Parts of the
body could be trapped in the closing area in the process. This poses an increased risk of injury or
even fatal injury.
Make sure that no parts of the body are in the closing area. To stop the closing process, release
the switch or push the switch again to reopen the side window.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed (
page 91).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above.
Side windows
page 91).
Z
93
Advertisement
Table of Contents
